BOSS STANDARD 155cm - Made in Denmark - ModulMounter Engelsk

Our ModulMounters can at any time, as option be extended meter wise with or without light.

Standard is a 5mm cutting foil on tabletop, toolshelf on one side, and a big easy to acces undershelf for storing foil rools (without wooden shelf)

There are doppel steelrolls at one table end for foil rolls, preventing to put at bar through the rolls, even widther rolls than table width can be used.

All our ModulMounters can be totally dissasempled, to make it possible to enter even difficult acess areares.

All ModulMounters can always laminate the full table length, "no dead ends" f.eks. can a 3m ModulMounter laminate a standard plate of 305cm.

Alle vore ModulMountere arbejder elektrisk, ingen kompressor, ingen støj og ingen dårlig ryg, fordi der nu kan lamineres langs bordkanten.

Alle vore ModulMountere er udstyret med vor "Smart Bar", så der ikke skal fumles en stang gennem applikationsrullerne.

Alle vore ModulMountere kan hæves op til 10cm på de låsbare hjul.

Til alle vore flatbed-laminatorer kan der til enhver tid tilkøbes lyskuffer á 1meter med LED lys

An application roll holder can be mounted at table end for hanging up to 3 application rolls with roll centering.

A 260cm Keen Cut cutting maschine on a roller wagon can in sekonds be mounted at tableside for cutting foil- and Dibond plates in a 90 degree angel.

The roller wagon kan with our 20cm table extension be parked outside the table, to make it possible for the opperator to use the whole tablesurface as working area.

Our unique "TopClean" cleaning system that 100% removes all dust and dirt kan be mounted on all ModulMounter laminators. See video below.

Antistatisk 3 blower for hanging over the table remove all static electricity f.ex. when bagside folie is pulled off plates.